Sendwithus Connector Setup Guide
Connector Actions
Action Name | AudienceStream | EventStream |
---|---|---|
Send an Email | ✓ | ✗ |
Create a New Customer | ✓ | ✗ |
Delete a Customer | ✓ | ✗ |
Activate a Drip Campaign for a Customer | ✓ | ✗ |
Configure Settings
Go to the Connector Marketplace and add a new connector. Read the Connector Overview article for general instructions on how to add a connector.
After adding the connector, configure the following settings:
- API key
- Your API key can be found in your Sendwithus account.
- For more information, see Sendwithus Authentication.
Action Settings - Parameters and Options
Click Next or go to the Actions tab. This is where you configure connector actions.
This section describes how to set up parameters and options for each action.
Action - Send an Email
Parameters
Parameter | Description |
---|---|
Template |
|
Recipient Address |
|
Recipient Name |
|
Sender Address |
|
Reply To |
|
Sender Name |
|
Template Data |
|
ESP Account |
|
Locale |
|
Version Name |
|
Action - Create a New Customer
Parameters
Parameter | Description |
---|---|
|
|
Locale |
|
Action - Delete a Customer
Parameters
Parameter | Description |
---|---|
|
Action - Activate a Drip Campaign for a Customer
Parameters
Parameter | Description |
---|---|
Drip Campaign ID |
|
Recipient Address |
|
Recipient Name |
|
Sender Address |
|
Reply To |
|
Email Data |
|
ESP Account |
|
Locale |
|
This page was last updated: July 10, 2020